Message Boards

Topic: Odamex Doom Builder Config?  (Read 5098 times)

Offline Springy

  • Posts: 6
    • View Profile
Odamex Doom Builder Config?
« on: January 01, 2014, 17:48:55 »
Hi there, I basically want to be able to create a cross platform CTF map I've only made ST specific one's before (which will never see the light of day), but the only way I can think of perhaps doing this is through an Odamex configuration file. I did some searching, found a broken link but I came across a website with one, (see attached document), I copied and pasted this into a text file and put it in the config folder but unfortunately it doesn't seem to show when I begin a new map. It is a fairly old one I have been notified. I was wondering if anyone perhaps has a link to such a file or what you lot use to actually make a cross platform CTF map? I tried searching the Odamex wiki and message boards but nothing shows so I'm assuming people must be editing the Boom configuration.
« Last Edit: February 06, 2014, 09:14:15 by HeX9109 »

Offline Hekksy

  • Doomin' since '96
  • Administrator
  • Posts: 153
    • View Profile
Re: Odamex Doom Builder Config?
« Reply #1 on: February 06, 2014, 09:15:26 »
Most people just edit using a Skulltag config and avoid using Skulltag stuff.

We used to have a Boom config that included the CTF flags, but this was a long time ago before Odamex supported ZDoom stuff like ACS and slopes
Join the Odamex Steam group! http://steamcommunity.com/groups/odamex
Check out the Odamex Discord as well: https://discord.gg/vHUu236